25 ~ Friday, June 20, 1986 - North Shore News DESIGN. AN. ENTERTAINING AREA aying paving ¢= LL Home Finishing & Design an be easy SUMMER IS: the time for barbecues on the patio. ._ * In’ case “you: haven’: laid that patio yet, . the - following step-by- step: Procedure. should prove stly; “mark out. the area to be paved and excavate to the required ‘depth: and. falls, “thoroughly con- solidating-the base of the excava- before putting down the sub- ant laying from 3 a fixed line, deally a house wall. Oy ‘25mm-38mm thick bed of écreeded sand — or with fist-sized mortar dabs (one at each corner and one in the middle). For -heavier use (garden. fur- niture or. garden machinery) ‘a. 50mm layer of sub-base is required‘ below the sand laying cotirse... Paving should be laid and levell- - ed gently. Using. the shaft of a club hammer. or apiece of wood, tap and check frequently until the cor- rect level i is achieved, . FILL CAREFULLY |. Lay’ only full: slabs fi sti, ‘edge. detailing can be done last.: 37.3): vy ‘Consistent width of joint can be > edge. on:.a: wooden batten;. then ’ firmly tap along the back line until achieved -using 6-8mm thick’ strips Of wood placed between the pav- ings. These should-be removed be- fore the mortar has set... ; Care should: be: taken to keep : mortar off the paving: surface as this can cause staining. Joints can then be filled’ by brushing in a dry sand cement mix, or for best results, cover the pav- ing edges with masking tape and carefully fill. and compact the joints with mortar. The dry sand/ cement method’ should only ‘be carried out on dry days. ~To cut a paving, carefully score a-line at the desired’ position on both sides and edges of the slab. Carefully chip a groove along -« , the entire, line: with the chisel and: club hammer, using progressively firmer strokes.” So Lay. the paving face down, ‘one the slab breaks. ; Cast paving is more difficult to cut. Extra care should be taken at the design stage to avoid the. need for cutting, whenever possible. ae 08 off Traditional Furniture Clearance